It is now feasible to make a prized material for spintronic devices and semiconductors: monolayer graphene nanoribbons with zigzag edges. Miniscule ribbons of graphene are desirable building blocks for semiconductor devices because of their predicted electronic properties, but making these nanostructures has remained a challenge. A team of researchers from China and Japan have devised a new method to make the structures in the lab; their findings appear in the current issue of Applied Physics Letters.

“Many studies have predicted the properties of graphene nanoribbons with zigzag edges,” said Guangyu Zhang, senior author on the study. “But in experiments it’s very hard to actually make this material.”

Researchers have previously tried to make graphene nanoribbons by placing sheets of graphene over a layer of silica and using atomic hydrogen to etch strips with zigzag edges, a process known as anisotropic etching. These edges are crucial to modulate the nanoribbon’s properties. This method only worked well to make ribbons that had two or more graphene layers, however. Irregularities in silica created by electronic peaks and valleys roughen its surface, so creating precise zigzag edges on graphene monolayers was a challenge. Zhang and his colleagues from the Chinese Academy of Sciences, Beijing Key Laboratory for Nanomaterials and Nanodevices, and the Collaborative Innovation Center of Quantum Matter teamed up with Japanese collaborators from the National Institute for Materials Science to solve the problem.

New Solution

The team replaced the underlying silica with boron nitride, a crystalline material that’s chemically sluggish and has a smooth surface devoid of electronic bumps and pits. By using this substrate and the anisotropic etching technique, the group successfully made graphene nanoribbons that were only one layer thick and had well-defined zigzag edges.

“This is the first time we have ever seen that graphene on a boron nitride surface can be fabricated in such a controllable way,” Zhang said.

The zigzag-edged nanoribbons showed high electron mobility in the range of 2,000 cm²/Vs, even at widths of less than 10 nm (reportedly the highest value ever reported for these structures), and created clean, narrow energy band gaps, which makes them promising materials for spintronic and nano-electronic devices.

“When you decrease the width of the nanoribbons, the mobility decreases drastically because of edge defects,” said Zhang. “Using standard lithography fabrication techniques, studies have seen mobility of 100 cm²/Vs or even lower, but our material still exceeds 2,000 cm²/Vs even at the sub-10 nanometer scale, demonstrating that these nanoribbons are of very high quality.” 

In future studies, extending this method to other kinds of substrates could enable the quick large-scale processing of monolayers of graphene to make high-quality nanoribbons with zigzag edges.  

For more information, visit www.aip.org.